Watco Flowpatch Asphalt Repair - Heavy duty repairs for asphalt and tarmac - Floor Repair

Asphalt Repair 

• Tough, fibre reinforced repairs for heavy wear areas
  
• Just add water, mix & pour
  
• Can be applied to damp (not wet) asphalt & tarmac
  
• Use at any depth from 5mm to 100mm in one layer
  
• Sets at temperatures as low as 5°C

Description

For decades we’ve been recommending our bestselling Flowpatch® pourable repair mortar for fast, pourable and strong repairs to concrete. Now, we’ve reformulated this winning formula so you can use it to repair asphalt and tarmac surfaces too.

The surface of asphalt and tarmac erodes over time, due to general wear and tear, causing the surface to become dished and damaged. Traditionally, repairs would involve cutting out around the damaged asphalt and refilling with a similar material. With Watco Flowpatch Asphalt Repair, just pour the mixture straight over the top of the surface erosion and used to fill holes up to 100mm deep in just one layer.

Recommended areas of use

• Car parks
  
• Loading areas
  
• Drives
  
• Paths
  
• Internal asphalt floors
  

Features

• Tough, fibre reinforced repairs for heavy wear areas
  
• Just add water, mix & pour
  
• Can be applied to damp (not wet) asphalt & Tarmac
  
• Use at any depth from 5mm to 100mm in one layer
  
• Sets at temperatures as low as 5°C
  
• Accepts heavy traffic, including forklifts after just 2 hours
  
• Resists oil and grease
  
• Will not dust or deteriorate with freeze/thaw conditions
  
• Mix as much as you need and reseal the pack for future use
  

Coverage: Approximately 0.5m2 at 25mm thickDescription