CXA - Air Separator
The Dutypoint CXA air separator units are installed to efficiently remove air and micro bubbles from the system. In heating systems, an air separator should be installed in the flow loop where the system experiences the highest temperature (next to the heat source) and lowest pressure. Air separators should ideally be installed immediately after the boiler and prior to the pump suction port as this is where the formation of micro bubbles is greatest. In a chilled water system the unit must be located in the return loop just prior to the chiller.
Specification Details
Please note that these product properties are not a replacement for the manufacturer's literature and it is always recommended that Dutypoint Systems is consulted before specifying.
Size & Weight
|
||
| Diameter (?) | 50 - 300 mm | |
| Volume (Litres) (?) | 5 - 360 l | |
| Weight (?) | 15 - 400 kg | |
Commercial
|
||
| Typical Use (?) | Boilers , Chillers , Control valves , Pumps | |
Other
|
||
| Uniclass (?) | Pr_70_60_37 Heat pumps | |
Technical
|
||
| Flow Rate (?) | 130 - 4580 l/min | |
| Operating Pressure (?) | 10 bar | |
| Temperature (?) | 110 °C | |
Materials & Finishes
|
||
| Material (?) | Carbon Steel , Polypropylene , Stainless steel | |
Similar Circulators / In-line Pumps Products
Contact
Contact
Contact