Proctorwrap®

Proctorwrap® is a spunbonded polypropylene film laminate material developed primarily as a breather membrane for use in timber frame wall and light steel frame applications. Applied in the factory during manufacture or on site, Proctorwrap affords effective protection of timber frames during construction against wind-driven rain, snow and dust. Once completed, the high water vapour permeability of Proctorwrap allows the controlled escape of vapour from within the timber frame whilst restricting the ingress of rain and moisture.
Proctorwraps’ vapour resistance of Sd 0.02m is less than the maximum permitted in NHBC requirements. Used in accordance with this NHBC Practice Note, Proctorwrap provides a superior quality permanent wall breather membrane.
Proctorwrap is suitable for use in exposed areas such as coastal areas due to its’ increased W1 resistance. This allows the use of Proctowrap in walls in all areas of the UK.
Increased airtightness over traditional breather membranesHighly water resistantAllows temporary protection until primary external covering is installed / appliedProvides durability and reduced risk of tears and subsequent remedial workAirtight and vapour permeable

Frameshield 100 is produced by the continuous extrusion
of polypropylene fibres which are then spun and bonded
together with a combination of heat and pressure.
Installed in accordance with the NHBC standards, Frameshield
100 will comply with all current UK. Building Regulations.
Application Details
Supplied in roll form, Frameshield 100 should be fixed to
frames with austentic stainless steel nails or staples at centres
not more than 500mm. On areas where sheets are required
to be lapped, the following dimensions must be adhered to:
Vertical Laps not less than 150mm
Horizontal laps not less than 100mm
Ensure integrity of Frameshield 100 by overlapping upper
layers over lower layers and staggering vertical joints. Protect
timber at wall plate level and mark stud positions for wall
fixings.
Application Procedure
Frameshield 100 must be installed in accordance with the A.
Proctor Group s instructions.